I've been doing miniatures for a long, long time. I made this one several years ago and started with a just a sketch. I'm getting back into miniatures this year so I thought I would re-visit how I made some of my older minis and mix in some new makes. I am combining two sites because they often go together in the world of miniatures. Digital prints are used everywhere from floors to walls to rugs and dishes, etc.
When I was designing a Vardo I did quite a few sketches before I found what I liked best. First I made a mock up out of poster board and heavy card and taped it together for fit. I made adjustments and used it for a pattern. When everything fit together pretty well I used the templates to cut out my wood pieces from 1/4" subflooring.
I was already planning on how I wanted to decorate the inside. The inside of these gypsy wagons were pretty ornate. I sketched an internal wall the way I want to make it. I will use it as a guide to make the wooden wall for the bed and under storage. I'm going to do mirrored panels that slide shut to close the bed off from the living area.

The roof is a little tricky and I can tell you that thin sheets of balsa and poster board work wonderful to bend it into shape. You hold the shape with rubber bands while the glue dries overnight between the layers. Then the mollicroft rectangle is cut out and built.
I had a little trouble with the wheels because I couldn't find spoke wheels locally. So I bought flat 2-1/2" wheels and 4" wooden rounds, then decorated them with a foam core rim, cutting skewers and chopsticks for spokes.




Comments
Post a Comment
Thank you for taking the time to comment. Comments are being spam filtered and are usually added within the hour.